Blog
PLA vs PETG vs TPU: which filament should you use?
How the three most popular FDM filaments differ in strength, print temperature, difficulty and real-world use.
Most people start with PLA. A few weeks later they need parts that resist heat, take impacts or flex — that is where PETG and TPU come in.
PLA — the easy default
- Nozzle: about 190–220 °C. Bed: 50–60 °C (optional).
- Pros: easy to print, nice surface, many colours, little odour, cheap.
- Cons: more brittle than PETG and softens at about 55–60 °C — not for parts left in a hot car.
- Use for: models, decorations, prototypes, indoor brackets, enclosures for low-heat electronics.
MakerLab PLA 1.75mm 1kg is our recommendation for beginners; it prints well on default slicer profiles.
PETG — tough and more heat-resistant
- Nozzle: about 230–250 °C. Bed: 70–85 °C.
- Pros: good impact resistance, handles about 70–80 °C, excellent layer adhesion.
- Cons: prone to stringing and can bond too strongly to smooth PEI — use a thin layer of glue stick as a release agent.
- Use for: mechanical parts, clips, sheltered outdoor mounts, electronics enclosures, robot parts.
Tip: run the part fan at 30–50 %, tune retraction gently and print a bit slower than PLA.
TPU — flexible
TPU behaves like rubber; 95A is flexible yet stiff enough for most printers.
- Nozzle: about 210–230 °C. Bed: 40–60 °C.
- Pros: elastic, abrasion- and shock-resistant.
- Cons: print slowly (20–40 mm/s); long bowden setups jam easily, direct drive is more reliable. Minimise retraction.
- Use for: phone cases, anti-slip feet, robot wheels, gaskets, dampers.
Comparison
| PLA | PETG | TPU 95A | |
|---|---|---|---|
| Difficulty | Easy | Medium | Harder |
| Nozzle temp | 190–220 °C | 230–250 °C | 210–230 °C |
| Heat resistance | ~55 °C | ~75 °C | ~80 °C |
| Character | Stiff, brittle | Stiff, tough | Elastic |
These figures are guidelines — always follow the range on the spool label and print a temperature tower with a new spool.
Storage
All three absorb moisture, especially TPU and PETG. Wet filament crackles, bubbles and strings. Store spools sealed with desiccant; dry wet filament in a filament dryer (PLA 45–50 °C, PETG 60–65 °C, TPU 50–55 °C for 4–6 hours).
Safety
The nozzle runs above 200 °C — do not touch it while printing or just after. Print in a ventilated room; melting plastic releases ultrafine particles even with PLA.
Quick pick
Beginner or models: PLA. Functional, moderately heat-resistant parts: PETG. Soft, elastic parts: TPU.
Per SHINDIY policy, filament is a consumable: no warranty and no returns once the seal is opened, except for wrong items or manufacturer defects found at inspection.